:	Jul 12, 2004

.

Disconnect the battery ground cable.

.

Remove the engine cover.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Drain the engine oil.

.

Remove the oil temperature sensor.   Disconnect the engine oil temperature sensor electrical connector.   Remove and discard the O-ring seal.

.

Disconnect the engine wiring harness.   Release the engine wiring harness from the retaining bracket.

.

Remove the oil pan.   Remove the 14 oil pan bolts.   Remove and discard the gasket.

.

Install the oil pan.   Clean the component mating faces.   Install a new gasket.   Evenly and progressively tighten the bolts to 10 Nm (7 lb.ft).

.

Connect the engine wiring harness.   Attach the engine wiring harness to the retaining bracket.

.

Install the oil temperature sensor.   Install a new O-ring seal.   Tighten the sensor to 10 Nm (7 lb.ft).   Connect the electrical connector.

.

Fill the engine with oil.

.

Install the engine cover.

.

Connect the battery ground cable.